Aegis AEGIS 1000 Manuel d'installation télécharger pdf (Page 19)

Page 19

REMOTE ARM/DISARM SWITCH

1. If desired, a remote keyswitch, keypad, or hidden arm/disarm toggle can be connected to the system. The device should have

a momentary close type switch.

2. Configure one of the zone inputs as a KEYSWITCH zone. A closure of the switch contacts will toggle the arming mode

between OFF and AWAY (Entry and Exit delays are still active).

3. Configure one of the outputs as an "ARMED" and another output as an "OK TO ARM" output. These outputs are used to

activate a red and a green LED based on the state of the alarm system. The "ARMED" and "OK TO ARM" outputs can

supply a maximum of 100 mA each. These outputs are included in the total DEVICES load, which cannot exceed 500 mA.

MOMENTARY CONTACT

KEYSWITCH

RED GREEN

-

+ +

GREEN

YELLOW

BLACK

RED

GREEN

YELLOW

BLACK

RED

FIGURE 8 - REMOTE KEYSWITCH CONNECTIONS

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 49 50

Commentaires sur ces manuels

Pas de commentaire